Bartscher GL-30 G Mode D'emploi page 8

INSTRUCTION FOR USE
Attention!
When the hot-plate smokes after the fi rst switching it on it is necessary to leave the device on at least for an
hour until the smoke disappears.
• Ignition of the main burner and regulation of the temperature: pictures A,B
Turn the regulation knob (2) into position „ignition of the main burner" and then press it down and hold it.
Press down the piezo knob of the ignitor several times (1) until the main burner burns. The fl ame is visible
through the slot in the front panel. After ignition of the burner hold the knob (2) pressed several seconds till
the thermofuse gets hot. Then release the button. If the fl ame goes out repeat the whole process once more.
• Lower performance sporo: picture A.B
By turning the knob (2) into position „sporo" you set the burning of the burner for sporo (lower performance).
• How to switch the whole device off: picture A,B
Turn the knob (2) into position"0".
Bowl for superfl uous oil
Check this bowl regularly and empty it in time. You must clean the bowl after each switching the device off.
ATTENTION! THIS BOWL CAN BE HOT WHEN THE DEVICE IS ON. EMPTY IT WHEN THE DEVICE IS
COLD.
1
7
2
Piezzo knob
1
Regulation knob
2
0
Switch off
Switch on the main
burner
Sporo (lower
performance)