Publicité
Les langues disponibles
Les langues disponibles
Maintenance
CAUTION
• Do not use a steel-wool pad or abrasive cleaner, which can scratch or damage the
enamel surface.
• Do not remove the cooktop surface to clean it. The gas lines leading to the burner
manifolds can be damaged, resulting in a fire or system failure.
Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
2
1
3
7
8
6
Top
Bottom
22 English
1. Remove the burner grates.
2. Remove the burner caps from the
burner heads.
3. Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4. Clean all removable grates and burner
components in warm, soapy water. Do
not use steel-wool pads or abrasive
cleaners.
5. Rinse and dry the grates and burner
components thoroughly.
6. Return the burner heads to their
positions on top of the manifold valves.
Make sure a starter electrode is inserted
through the hole in each burner head.
7. Return the burner caps to their positions
on top of burner heads. To ensure
proper and safe operation, make sure
the burner caps lie flat on top of the
burner heads.
8. Reinstall the burner grates in their
respective positions.
9. Turn on each burner and check if it
operates properly. After verifying that a
burner operates normally, turn it off.
NOTE
• After cleaning, confirm that the burner port openings aren't plugged.
• Shake out any excess water and then let burner heads and caps dry thoroughly.
Placing the center burner upside down will allow the water to drain out more
easily.
• Do not wash any burner components in a dish washer.
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by
force.
• Make sure all burner components (heads and caps) are reinstalled properly. They
are stable and rest flat when installed properly.
• To avoid chipping, do not bang grates and caps against each other or against
hard surfaces such as cast iron cookware.
• Do not attempt to remove center oval burner cap from the head.
Publicité
