Getting Started; Turning Power On And Off; Initial System Start-Up; Setting Time - Alpine CDA-9847 Mode D'emploi

Getting Started

SOURCE/ Rotary
POWER encoder
MUTE
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote control
sensor.
About the alphanumeric display of this unit
• All English lower case characters are displayed as
upper case on this unit.
• The alphanumeric display in the following table shows
alphanumeric characters/numbers that may be difficult
to distinguish.
0 2
Alphanumeric
Display
G H
Alphanumeric
Display

Turning Power On and Off

Press SOURCE/POWER to turn on the unit.
• The unit can be turned on by pressing any other button except eject
c and TITLE .
Press and hold SOURCE/POWER for at least 2
seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.
6
-EN
Remote Sensor
TITLE
5 6 8 A B D
K M Q R S Z

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first
time, after installing the CD changer, after changing the car battery, etc.
1
Turn off the unit power.
2
Remove the detachable front panel.
3
Press RESET with a ball-point pen or similar
pointed object.
RESET switch

Setting Time

1
In the Clock priority mode, press and hold TITLE
for at least 2 seconds while the time is displayed.
The time indication will blink.
2
Turn the Rotary encoder to adjust the hours
while the time indication is blinking.
3
When the hour has been adjusted, press the
Rotary encoder.
4
Turn the Rotary encoder to adjust the minutes
while the time indication is blinking.
The time is automatically set 5 seconds after the minute
adjustment. The time can also be manually set by
pressing the Rotary encoder.
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold the Rotary encoder for at least 2
seconds after setting the "hour." Minutes will reset to 00. If the
display shows over "30" minutes when you do this, the time will
advance one hour.

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its
previous level.
1