BWT BC Serie Manuel D'utilisation page 6

3. Plug the jack of the external adaptor into the charging port at the end of
the charging base.
4. Connect the external adaptor to the power source. Once the pool vacuum
begins charging, the indicator light on the external adaptor will turn red.
Normally, it takes about 4-6 hours to reach a full charge. The indicator
light will turn green when the pool vacuum is almost fully charged.
NOTE: if the motor is generating noise, ensure "OFF" is selected on the
power switch.
 Immediately disconnect the external adaptor from the power source if you
detect any of the following:
- Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
5. When charging is complete, disconnect the external adaptor from the
power source and detach the charging base from the unit and external
adaptor.
Normally, the pool vacuum can operate up to 30 minutes on a full charge (charged for
4-6 hours)
Note: Clean the filter cage regularly. Excessive debris inside the filter cage increases the
burden to the motor operation and shortens the operating duration as a result.
FACT: Rechargeable lithium-Ion battery is classified as a consumable item. It has a
limited life and will gradually lose its capacity to hold a charge. Therefore, running time of
the pool vacuum will gradually reduce through repeated charging and discharging in
operation.
Once the lifespan of the battery reaches its end, refer to section "BATTERY DISPOSAL"
for instructions regarding battery disposal.
NOTE: Let the pool vacuum rest for 30 to 40 minutes before charging it again.
5/155