EUROM 350623 Manuel D'utilisation page 25

recognised electrician to be checked and/or repaired. Always ask for original parts to
be used.
4. The device may only be opened and/or repaired by a competent and qualified
person. Do not carry our your own repairs as this could be dangerous! Repairs carried
out by unauthorised persons or changes made to the device could damage the
dust/waterproof capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the manufacturer, their
service department or somebody with similar qualifications in order to prevent
creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or personal injury. They
will invalidate the guarantee and the supplier, importer and/or manufacturer shall not be
liable for the consequences.
Description
1. Control dial
2. Thermostat dial
3. Pilot light
4. Fan grille
Location and connection

Remove all packaging material and keep out of
reach of children. After removing packaging, check the appliance for damage or other
signs that could indicate a fault/defect/malfunction. In case of doubt, do not use the
appliance, but contact your vendor for inspection or replacement.

Select a suitable location for the device taking into account all the warnings mentioned
earlier in this manual.

Fully extend the power cord and plug into a suitable 220-240V socket. To prevent the
circuit overloading, check that no other appliances are connected to the same group.
Set-up and Operation

Turn the thermostat dial to maximum (clockwise as far as possible).

Switch the heater on by turning the control dial to one of the following three positions:
Fan only (thermostat always to maximum
I Heating at half power (1000W)
II Heating at full power (2000W)
25