3. OPERATING INSTRUCTIONS
The Power indication light will turn on when the unit is plugged in,
regardless of whether the unit is operating or not.
1. Turn on/off
Press
to start the unit, when the unit is stop; or press
shutdown it, when the unit is operating.
2. Humidity setting
Press the
key to enter humidity-setting state, then press ▲
or ▼ to adjust the humidity from 40% to 80%, every setting is
5%, the LED flashing display when adjusting. Stop pressing for
5 seconds, it will return to normal display. The default value of
humidity is 40%.
3. Fan-speed setting
Press
to set the fan speed to high or low, and the corre-
sponding fan speed light will be lighted.
4. Swing setting
After the machine is started, press
outlet leaf's swing.
5. Time-setting
Press
to enter boot-time setting state when the unit is stop,
then the LED will display the time, you may press ▲ or ▼ button
to adjust the automatic boot time from 1 to 24 hours. Press
to enter shutdown-time setting state when the unit is running,
then the LED will display the time, you may press ▲ or ▼ button
to adjust the automatic shutdown time from 1 to 24 hours. The
programmed time remains unchanged if the machine stops to
work due to water full or during defrosting. Once turned on or
off by user, the timer function will be canceled.
4. DRAINING THE COLLECTED WATER
When the drainage tank is full, the tank full indicator light will turn
on, the operation will stop automatically and the buzzer will beep
15 times to alert the user, that the water need to be emptied from
the drainage tank.
5. EMPTYING THE DRAINAGE TANK
1. Lightly press on the sides of the tank with both hands and pull
the tank out gently.
2. Discard the collected water.
to
to start or stop the air-
4
NOTE
1. If the drainage tank is dirty, wash it with cold or lukewarm water.
Do not use detergent, scouring pads, chemically treated dust
cloths, gasoline, benzene, thinner, or other solvents, as these
can scratch and damage the tank and cause water leakage.
2. When replacing the drainage tank, press the tank firmly into
place with both hands. If the tank is not positioned properly, the
"TANK FULL" sensor will be activated, and the dehumidifier will
not operate.
6. CONTINUOUS WATER DRAINAGE
The unit features a continuous drainage port. Using a plastic pipe
(with an inner diameter of 10 mm) inserts into drain hole (on inter-
mediate plate), reach out from side of water tank, install it in place,
and arrange the drain pipe.
The water in the drainage tank can be continuously drained out
from the continuous port on the unit.
ENGLISH