Fit The Receiver Collar - Petsafe PDT20-11738 Manuel D'utilisation

Step

Fit the Receiver Collar

3
Important: The proper fi t and placement of your Receiver Collar is important
for effective operation.
To assure a proper fi t, please follow these steps:
1. Make sure that the Receiver Collar is turned off.
2. Start with your dog standing comfortably.
3. Place the Receiver Collar high on your dog's neck close to
the ears. Center the Receiver Collar underneath your dog's
neck, touching the skin. Make sure the PetSafe
front of the unit is upright. Note: For long-haired dogs, it may
be necessary to trim the neck hairs along the path of the spray. It
is important that the spray reaches the dog's snout to be effective.
4. The PetSafe QuickFit
you can quickly attach and remove the Receiver
Collar from your dog while maintaining the
desired fi t.
a. With the Snap Buckle fastened, thread the
collar through the Metal Buckle.
b. Slide the excess collar through the "C" Loop on top of
the Snap Buckle. This will hold the collar in place.
c. Once the collar fi t is determined, simply use the Snap Buckle to
remove and replace the collar.
5. The Receiver Collar should fi t snugly, yet loose enough to allow
one fi nger to fi t under the strap. Allow your dog to wear the collar
for several minutes, then re check the fi t. Check the fi t again as
your dog becomes more comfortable with the Receiver Collar.
6. Trim the collar as follows:
a. Mark the desired length of the collar with a pen. Allow for
growth if your dog is young or grows a thick winter coat.
b. Remove the Receiver Collar from your dog and cut off excess.
Important: The Receiver Collar should not be worn for more
than 8 hours out of every 24-hour period
8
™
Collar is designed so
www.petsafe.net
®
logo in the
YES
NO