Kenwood Chef XL Sense KVL60 Serie Instructions page 7

5720000183 Iss 1 KVC50_KVL60 multi_5720000173 Iss 1 KVC50_KVL60 Eng_Arabic 20/05/2014 08:06 Page 8
To fit and use your
Splashguard
To assemble
The splashguard assembly consists of 2
pieces: the head shield
bs
splashguard .
The splashguard cannot be fitted to the
bowl unless the shield is fitted.
1 Raise the mixer head until it locks.
2 Clip the head shield upwards onto the
underside of the mixer head
located.
3 Fit the bowl onto the base.
4 Lower the mixer head.
5 Rest the splashguard on the bowl rim
and then slide forward until fully located
9
.
• During mixing, ingredients can be added
directly to the bowl via the feed chute.
6 To remove the splashguard simply slide it
away from the mixer bowl.
7 To remove the head shield, raise the
mixer head until it locks. Remove the tool
if fitted, then pull the head shield
downwards from the underside of the
mixer head.
Note: Only fit or remove the splashguard
when the mixer head is in the locked
position.
We recommend that the head shield
is removed regularly from the mixer
head for cleaning.
br
and the
8
until fully
8
Tool Adjustment
K-beater & Whisk
The tools are set to the correct height for
the bowl supplied in the factory and should
not require adjustment.
However, if you wish to adjust the tool use
a suitable sized spanner:
TYPE KVC50 = 17mm
TYPE KVL60 = 19mm
Then follow the instructions below:
1 Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the clearance
needs to be adjusted, raise the mixer
head and remove the tool. Ideally the
whisk and K-beater should be almost
touching the bottom of the bowl
4 Using a suitable spanner loosen the nut
sufficiently to allow adjustment of the
bl
shaft . To lower the tool closer to the
bottom of the bowl, turn the shaft anti-
clockwise. To raise the tool away from
the bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the
mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once this is
achieved tighten the nut securely.
bl
• Note: Spanner shown is for
illustration purpose only.
Dough Hook
This tool is set at the factory and should
require no adjustment.
bk
.