Domo DO91202F Mode D'emploi page 57

2. Loosen the screws of the top hinge and remove the hinge.
3. Lift the door and place it on a padded surface to prevent it from being scratched.
4. Loosen the screws ③ at the bottom of the door, then remove the stop block ② and the door stop ①
from the bottom. Replace the door stop ① and stop block ② on the left side, and tighten the screws
③ firmly.
5. Carefully tilt the device backwards. Loosen the bottom hinge ③ + ④. Remove the screw cover cap
① and the levelling foot ② from the left side, and attach to the right side.
! Attention: the inclination of the freezer must be less than 45° so that the compressor oil does not
enter the cooling circuit. If you do shut down the unit completely, wait 12 hours before turning it back on.
www.domo-elektro.be
①
②
③
DO91202F
57