MSI MPG Z790 CARBON WIFI Manuel D'utilisation page 50

⚠
CAUTION
Do not connect the wrong type of LED strips. The JRGB connector and the JARGB_V2
connector provide different voltages, and connecting the ARGB 5V LED strip to the
JRGB connector will result in damage to the LED strip.
⚠
Important
If you connect the ARGB Gen1 and ARGB Gen2 LED strips into the same connector, it
∙
may cause some issues. Please do not mix the ARGB Gen1 LED and the ARGB Gen2
LED strips together.
∙ It is recommended that you install LED strips with the same specification to achieve
the best effects.
Always turn off the power supply and unplug the power cord from the power outlet
∙
before installing or removing the addressable RGB LED strip.
Please use MSI's software to control the extended LED strip.
∙
JOCFS1: Safe Boot Jumper
This jumper is used for Safe Boot. Once enabled, the system will boot with default
settings and lower PCIe (from CPU) mode.
Normal
(default)
Boot with the saved
BIOS settings.
48
Enabled
Apply the BIOS default
settings and lower PCIe
(from CPU) mode for
Safe Boot