Publicité
ATTENTION: DO NOT vent under any porch, deck, awning, or in any semi enclosed or roofed area. Doing so
may result in unpredictable airflow at the vent cap under certain conditions and can affect the performance
INSTALLATION OPTIONS
Read this entire manual before you install and use your pellet stove. Failure to follow instructions may result in
property damage, bodily injury, or even death!
(See specific installation details for clearances and other installation requirements)
A Freestanding Unit—supported by pedestal/legs and placed on a non-combustible floor surface in compliance
with clearance requirements for a freestanding stove installation.
Your pellet stove may be installed to code in either a conventional or mobile home (see SPECIAL MOBILE HOME
REQUIREMENTS). The installation must comply with the Manufactured Home and Safety Standard (HUD), CFR3280,
Part 24.
It is recommended that only a authorized technician install your pellet stove, preferably an NFI certified specialist.
DO NOT CONNECT THIS UNIT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM.
The use of other components other than stated herein could cause bodily harm, heater damage, and void your
warranty.
IMPROPER INSTALLATION: The manufacturer will not be held responsible for damage caused by the malfunction
of a stove due to improper venting or installation. Call (800) 750-2723 and/or consult a professional installer if you
have any questions.
CLEARANCES
Your pellet stove has been tested and listed for installation in residential, mobile home in accordance with the
clearances given below. For safety reasons, please adhere to the installation clearances and restrictions. Any
reduction in clearance to combustibles may only be done by means approved by a regulatory authority.
CLEARANCES
A
Side Wall to Stove
B
Side Wall to Vent Pipe
C
Back Wall to Stove
D
Back Wall to Vent Pipe
E
Ceiling to Floor
F
Ceiling to Stove
CORNER CLEARANCES
G
Side Wall to Stove
H
Side Wall to Vent Pipe
I
Back Wall to Stove
J
Back Wall to Vent Pipe
FLOOR PROTECTOR DIMENSIONS
K
Back to Stove
L
Side to Stove
M
Front to Stove
N
Back and Sides to Flue 6" (153mm)
FLOOR PROTECTION
This heater must have a non-combustible floor protector (UL1618 ember protection) installed beneath it if the
floor is of combustible material.
to each side, 1" to the rear of the unit. Under and 2" beyond each side of the cleanout tee if an interior vertical instillation.
Canada: Floor protector should comply with CAN/ULC standards. Needs to extend 18" to the front, 8" beyond each side of
the unit.
Installation
of your stove, as well as, other unforeseeable issues.
C
C
inches
mm
C
C
8
204
12
305
12
305
3
77
84
2134
46.875
1191
10
254
3
77
10
254
3
K
77
L
1" (26mm) U.S.
(8" (204mm) Can.)
6" (153mm) U.S.
K
(8" (204mm) Can.)
L
6" (153mm) U.S.
(18" (458mm)Can.)
THROUGH THE WALL
US: Floor protector should be UL listed or equal too, needs to extend 16" to the front, 8"
B
A
C
B
B
A
A
E
K
L
K
L
L
THROUGH THE WALL
K
INSTALLATION
L
L
L
M
M
THROUGH THE WALL
M
M
INSTALLATION
INSTALLATION
THROUGH THE WALL
THROUGH THE WALL
INSTALLATION
INSTALLATION
-4-
B
F
A
E
E
B
F
A
E
ADJACENT WALL
G
H
D
D
G
F
F
E
ADJACENT WALL
ADJACENT WALL
G
G
H
H
J
J
I
L
I
L
M
N
N
INTERIOR VERTICAL
INSTALLATION
INTERIOR VERTICAL
INTERIOR VERTICAL
INSTALLATION
INSTALLATION
D
D
F
D
ADJACENT WALL
G
H
ADJACENT WALL
H
J
J
I
I
J
I
N
N
INTERIOR VERTICAL
INSTALLATION
INTERIOR VERTICAL
INSTALLATION
Publicité
