NEFF D99W59N0GB Mode D'emploi page 14

Filters and maintenance
Grease filters:
Metal filters are used to trap the greasy
element of the vapours that develop
during cooking.
The filter mats are made from non-
combustible metal.
Caution:
As the filter becomes more and more
saturated with grease, not only does the
risk of it catching fire increase but the
efficiency of the extractor hood can also be
adversely affected.
Important:
By cleaning the metal grease filters at
appropriate intervals, the possibility of them
catching fire as a result of a build-up of heat
such as occurs when deep-fat frying or
roasting is taking place, is reduced.
Saturation indicator:
When the grease filters are saturated an
acoustic signal is emitted and the fan
follow-on LED flashes. The grease filters
should be cleaned straight away.
Cleaning the metal grease filters:
In normal operation (1 to 2 hours daily),
the metal grease filter must be cleaned
1 x a month.
The filters can be cleaned in a dish-
washer. It is however possible that they
will become slightly discoloured.
The filter must be placed loosely, and
NOT wedged, in the dishwasher.
Important:
Metal filters that are saturated with
grease should not be washed together
with other dishes etc.
When cleaning the filters by hand, soak
them in hot soapy water first of all.
Do not use aggressive, acidic or caustic
cleaners.
Then brush the filters clean, rinse them
thoroughly and leave the water to drain off.
14
Removing and installing the edge
extraction segments and the
metal-mesh grease filters:
Attention: The halogen bulbs must be
switched off and must have cooled down.
1. Take hold of the edge extraction
segments at the side, pull them down
and remove, Fig. 1.
2. Depress the handles on the grease filters
and fold down the grease filters, Fig. 1.
3. Clean the grease filters.
4. Re-install the cleaned grease filters.
5. Attach the edge extraction segments in
reverse sequence.
6. Clear the saturation indicator
Switch on and then immediately
switch off the fan at an arbitrary step.
Press the button twice.
!
You will hear a signal and the LED
goes out.
Activated carbon filter:
For neutralizing odours in recirculating
mode.
Caution:
As the filter becomes more and more
saturated with grease, there is an increased
risk of fire and the function of the extractor
hood may be impaired.
Important:
Change the activated carbon filter promptly
to prevent the risk of fire from the
accumulation of heat when deep-fat frying
or roasting.
Saturation indicator:
When the activated carbon filter is
saturated an acoustic signal is emitted and
the lighting LED flashes.
The activated carbon filter should be
replaced straight away.
.