Haier HSU18VHJDB Mode D'emploi page 4

Operation
Sleep Operation
Before going to bed, you can simply press the
SLEEP button and unit will operate in SLEEP
mode and bring you a sound sleep.
Use of SLEEP function
After the unit starts, set the operation status,
then press SLEEP button before which the
clock must be adjusted and time being set.
Operation Mode
1. In COOL,DRY mode
1 hours after SLEEP mode starts, temp. will
O
become about 2 F higher than temp.setting. After
another 1 hours, temp. rises about 2
The unit will run for further 6 hours then stops
Temp. is higher than temp. setting so that room
temperature won't be too Iow for your sleep.
SLEEP operation starts
Approx.6hrs
1 hr
Rises about 2
1 hr
Temp.setting
In COOL, DRY mode
In HEAT mode
2.
1 hours after SLEEP mode starts, temp
will become about 4
setting. After another 1 hours, temp
decrease about 4
another 3 hours, temp. rises about 2
further. The unit will run for further 3
hours then stops. Temp. is lower than
temp. setting so that room temperature
won't be too high for your sleep.
Temp.setting
1 hr Decreases about 4
1 hr
Decreases about 4
3 hrs
SLEEP
operation starts
In HEAT mode
4
O
F further.
SLEEP operation stops
O
Rises about 2 F
O
F
Unit stop
F lower than temp.
O
F further. After more
O
F
O
Unit stop
F
O
O F
3 hrs
O
Rises about 2 F
SLEEP
operation stops
In AUTO mode
3.
The unit operates in corresponding sleep
mode adapted to the automatically selected
operation mode.
4. In FAN mode
It has no SLEEP function.
5. Set the fan speed change when sleeping
If the fan speed is high or medium before
setting for the sleep, set for low speed
after sleeping.
6. Note to the power failure resume:
press the sleep button ten times in five seconds
and enter this function after hearing four sounds.
And press the sleep button ten times within five
seconds and leave this function after hearing two
sounds.
NOTE:
With the power failure resume, when setting the
TIMER ON, TIMER OFF and TIMER ON/OFF,
it's memorized as shutdown status when resuming
after power out .
POWER/SOFT Operation
(1)
POWER Operation
When you need rapid heating or cooling, you can use this function.
In COOL mode, fan speed automatically takes high speed of
AUTO fan mode. In HEAT mode, fan speed automatically takes
medium speed of AUTO fan mode.
(2)
SOFT Operation
You can use this function when silence is needed for rest or reading.
In SOFT operation mode, fan speed
of AUTO fan mode.
Note
During POWER operation, in rapid HEAT or COOL mode the room
will show uniform temperature distribution. Long period
SOFT operation will cause effect of not too cool or not too warm.
To cancel POWER or SOFT operation
Press POWER/SOFT button again, POWER or SOFT disappears.
HEALTHY Operation
Healthy Negative ions
The anion generator in the airconditioner can
generate a lot of anion effectively balance the
quantity of position and anion in the air and also
to kill bacteria and speed up the dust sediment in
the room and finally clean the air in the room.
automatically takes low speed