CASO DESIGN 644 Mode D'emploi page 32

12.5.3 The handle installing
The wine cooler comes with one metal stainless steel handle. To install simply screw them to
the door with the supplied screws.
To do this, slide the rubber seal on the back of the door to the side to lay open the predrilled
holes. Use the included screws to install the handle on the door.
Then reinsert the rubber seal in the correct position.
12.5.4 Wooden shelves
upper shelf
Please note
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point.
Any of the shelves can be removed to
accommodate larger bottles.
Remove all bottles from the shelves.
Then press the locking mechanism on both
sides, it is located in the middle above the
wooden shelf. Then carefully pull out the wooden
shelf.
If you want to reinsert the wooden shelf, slide it over the rail completely into the device and
then release the locking mechanism again (2).
usual shelf lower shelf
32