Publicité
Les langues disponibles
Les langues disponibles
9. CLEANING AND MAINTENANCE
WARNING : Before cleaning or carrying
out maintenance, switch off the appliance,
disconnect the mains plug and turn off the
water tap.
Your dishwasher can only be repaired
by an authorized service agent. Do not
try to repair your machine unless any
recommendation by this manual
WARNING : All surfaces are susceptible
to scratching. Contact with unsuitable
cleaning agents can alter or discolor all
surfaces.
WARNING : Keep the floor around your
dishwasher clean and dry to prevent any
possible injury. We recommend to keep
your dish washer clean,empty and door
cracked open to allow air to circulate in
case of any extended unused time.
Dishwasher door can be damaged by
abrasive cleaners, scouring pads, abrasive
cloths. Cleaning the machine in regular
intervals prolongs the machine's service life.
Oil and lime may accumulate in the
machine's washing section. In case of such
accumulation; -Fill the detergent
compartment without loading any dishes
into the machine, select a program that runs
at high temperature, and start the machine.
In case of insufficiency, use special
cleansing mate-rial available in the market.
(Cleansing material produced special to
machines by detergent produc-ers.)
Cleaning the seals in the machine door,
- To clean any accumulated residues in the
door seals, wipe the seals regularly by using
a dampened cloth.
Cleaning the machine,
Clean the filters and spray arms at least
once a month.
Unplug your machine and turn off its tap
before starting the cleaning.
Do not use hard materials when cleaning
your machine. Wipe with a fine cleaning
material and a dampened cloth.
Filters
Check if any food wastes have remained on
the coarse and fine filters. If any food
wastes are left, remove the filters and clean
them thoroughly under the water tap.
30
Filter
a. Micro Filter
b. Coarse Filter
c. Metal/Plastic
1
3
Spray Arms
Check whether or not the holes for the
upper and lower spray arms are clogged.
If there is any clogging, remove the spray
arms and clean them under water.
You can remove the lower spray arm by
pulling it upwards, while the upper spray
arm nut can be removed by turning the
nut to the left.
Be sure that the nut is perfectly tightened
when refitting the upper spray arm.
2
b
a
4
c
Publicité
