Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR USE
AFTER USING THE MACHINE
After scrubbing-drying, before leaving the machine:
1.
Disconnect the brush/pad-holder as follows:
– Lift the brush/pad, turn the brush/pad switch (5, Fig.
B) to "I" and, after a few seconds, to "0", thus
releasing the brush/pad-holder.
2.
Empty the tanks (4 and 5, Fig. J) according to the
procedure shown in the previous paragraph.
3.
Perform the daily maintenance operations (see the
Maintenance chapter).
4.
Store the machine in a clean and dry place, with the
brush/pad and the squeegee lifted or removed.
RECOVERY WATER TANK REMOVAL
To check or charge the lead (WET) batteries, or to perform
other operations, it may be necessary to remove the recovery
water tank (1, Fig. H) according to the following procedure.
1.
Empty the recovery water tank (4, Fig. J) according to
the procedure shown in the relevant paragraph.
2.
Drive the machine on a level ground.
3.
Make sure that the switches (5 and 6, Fig. B) are turned
to "0".
4.
Disconnect the vacuum hose (22, Fig. C) from the
squeegee (11).
5.
Disconnect the recovery water drain hose (16, Fig. C)
from the bracket (17).
6.
Open the cover (6, Fig. C) and apply the cover stand (19,
Fig. J).
7.
Grasp the recovery water tank (1, Fig. H) in the area (2)
and slightly raise it.
8.
Disconnect the vacuum hose (3, Fig. H) from the tank,
then remove the tank (1) with the hoses (4) and (5).
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days,
proceed as follows:
1.
Perform the operations described in the After Using The
Machine paragraph.
2.
Remove the recovery water tank (1, Fig. H) according to
the procedure shown in the previous paragraph, then
disconnect the battery negative terminals (10, Fig. J).
3.
Reinstall the recovery water tank (1, Fig. H).
4.
Store the machine in a clean and dry place.
FIRST PERIOD OF USE
After the first period of use (first 8 hours) it is necessary to
check the fixing and connecting parts of the machine for
proper tightening. Check the visible parts for integrity and
leakage.
10
MAINTENANCE
The lifespan of the machine and its maximum operating
safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The
intervals shown may vary according to particular working
conditions, which are to be defined by the person in charge of
the maintenance.
WARNING!
Maintenance operations must be carried out
with the machine switched off and the
batteries/battery charger cable disconnected.
Moreover, carefully read all the instructions in
the Safety chapter.
All scheduled or extraordinary maintenance operations must
be performed by qualified personnel, or by an authorized
Service Center.
This Manual describes only the easiest and most common
maintenance procedures.
NOTE
For other maintenance procedures contained
in the scheduled maintenance table, see the
specific Service Manual that can be consulted
at any Service Center.
Razor SV17 — 909 6309 000(1)2006-01
Publicité
