Napoleon Woodland NEFI27H Instructions D'installation Et D'opération page 13

4.2 OPERATING BY REMOTE CONTROL
TO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY.
NOTE: When operating the remote control, it must be directed towards the front center of the log set.
The power button can be used to turn the log set on/off. Pressing
A.
this button
power button again will turn off the log set. The ember and log will
fade after 4 seconds after turning off the log set.
To adjust the flame brightness and ember log light, press the flame
B.
button . There is one ember log light and three flame brightness
levels to cycle through and then an off setting (LL, F1, F2, F3 and
then F0). F3 is the brightest flame level, LL is the ember log light
only.
To control the thermostat function press the thermostat button
C.
There are 7 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F 85°F
and off). The default setting will display Fahrenheit. Press the
thermostat button to cycle through the settings. Once you have
selected the desired temperature the heater will automatically
operate until that temperature is reached. When the room
temperature is 2 degrees lower than the temperature setting, the
heater will turn on.
To activate the heater and blower, press the heater button
D.
blower will turn on. Press the heater button again to set desired low
or high heat temperature; press the heater button again to turn off
the heater.
The timer controls all operating modes of the log set. To activate the
E.
timer, press the timer button
will appear on the LED display. To choose the desired time, continue to press the timer button, there
are 8 settings (30mins,1h, 2h, 3h, 4h, 5h, 6h and off). The fireplace will turn off at the setting time.
To turn off the log set, press the power button once on the remote, or press the power button once on
F.
the control panel on the unit.
NOTE: This hand held remote control must remain within 6 meters or 19 feet of the log set to be
effective.
4.3 REMOTE BATTERY INSTALLATION
1. To replace the existing battery, remote the battery
holder.
2. To remove the battery holder, turn remote onto
front side and press the left side lever towards the
center while pulling the battery holder out using the
slot provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into the
remote by sliding it into position, as shown.
4. Battery cover is secure onto the remote control
when a "CLICKING" noise is heard.
!
KNOT BEFORE THROWING AWAY.
activates the power to the log set. Pressing the
, the icon will illuminate and the time
WARNING
.
, the
BATTERY (CR 2025)
BATTERY COVER
13
EN
REMOTE
(REAR SIDE)
W415-1461 / C / 08.04.16