Klarstein Pro Master Jerky 300 Mode D'emploi page 43

CLEANING AND CARE
Note: Before cleaning or servicing the dehydrator, make sure that the mains plug is
disconnected and the mains switch is set to OFF.
• Clean the slots and the inside of the housing before using the dryer for the first time
and after each use.
• Turn the power switch and the timer knob to the OFF position. Unplug the power
cord from the wall outlet.
• Allow the dryer to cool completely before cleaning.
• Remove the racks from the dryer.
• Wipe the drying cabinet with a damp sponge or washcloth (inside and outside).
Be careful, the edges can be sharp! Do not splash water on the heating element
(behind the screen in the cabinet on the back). Water can damage the electrical
components and increases the risk of electric shock. Do not immerse the unit in
water.
• Clean the shelves of the dehydrating device with warm, soapy water. Rinse with
clear water and dry immediately.
TROUBLESHOOTING
Moisture In The Container
CAUSE:
Incomplete Drying . Food cut unevenly, thus incomplete drying .
Dried foods left at room temperature too long after cooling, moisture has re-entered the
foods.
PREVENTION:
Test food for dryness before removing from the dehydrator . Cut foods evenly. Cool
quickly and package immediately.
EN
43