Publicité
Les langues disponibles
Les langues disponibles
1. General Mode:
a. Press the "Display-Toggle" button to check the status of the UPS status:
b. Press and hold the "Display-Toggle" button for 4 seconds,
If the machine is in the Battery Mode with active alarm, it will become silent.
If the machine is in the Line Mode, a self- diagnostic test will take place.
c. If the "Display-Toggle" button remains untouched for over 30 seconds, the LCD backlight will turn off
automatically.
2. Set-up Mode
Step 1: Hold the "Display-Toggle" button for 10 seconds to enter the UPS Set-Up Mode.
Step 2: By pressing the Display toggle, users can switch between setup functions. Some User Configurable
functions are as follows:
a. Delay Time: The time delay between switching from Battery Mode to Line Mode. There are 9 different
settings. The default setting is 0 minutes.
b. Battery Pack Numbers: This function provides the estimated UPS runtime using various numbers of
battery packs. The default setting is 0.
c. Static Frequency Tolerance: There are 4 settings (1, 2, 4, 6 %), and the default setting is +/-6%.
Functional description: The setting may be adjusted to the quality of the electricity in use.
d. Slew rate: Also known as Dynamic Frequency Tolerance. There are 5 different settings (0.25, 0.5, 1, 2, 4
Hz/Sec). The fault value is 4Hz/sec. Functional Description: "Slew Rate" indicates the tolerance of a
device in accepting frequency variance. Lower "Slew Rate" results in less tolerance but better protection
for the connected load and vice versa.
e. Low Battery Shutdown Voltage: This function will adjust the UPS shutdown point according to the
battery's remaining capacity.
These programmable items are sorted by unit as in the following table：
Step 3: Press and hold the display-toggle for 4 seconds. When the icons blink, the value of each item is
changed by slightly pressing the toggle.
Copyright © 2009 CyberPower Systems, Inc.
LCD SETUP FUCTIONS
Item
1
Input Voltage
2
Output Voltage
3
Output Frequency
4
Load
5
Estimate Run Time
6
Load Capacity
7
Battery Capacity
8
Centigrade
9
Fahrenheit
Items
Delay Time
Battery Pack Numbers
Voltage Mode (220/230/240)
Static Frequency Tolerance
Slew Rate
Low Battery Shutdown Voltage
Firmware Version
Unit
V
V
Hz
Kw
Min
%
%
℃
℉
Unit
Min
A
V
%
Hz
V
None
8
Publicité
