Ryobi P251VN Manuel D'utilisation page 5

PRODUCT SPECIFICATIONS
No Load Speed .......................0-410/0-1,800 r/min. (RPM)
Clutch.................................................................24 position
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
FEATURES
Torque .................................................................. 750 in.lb.
Hammer Speed
(Blows per minute) ...................... 0-5,400/0-23,000 BPM
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
INSTALLING/ADJUSTING THE AUXILIARY
HANDLE ASSEMBLY
See Figure 1, page 10.
An auxiliary handle is packed with the drill for ease of
operation and to help prevent loss of control. The handle
can be mounted for left or right hand use.
 Insert the handle screw into the hole located above the
switch trigger and seat the hex head into the hole.
 Slide the handle collar onto the screw. Seat the hex end
of the collar into the hex hole.
 Thread the auxiliary handle onto the screw and tighten
securely.
5 — English