• Switch off the unit.
• Remove and store the sealing cap of the
condensate drain or the upper drain.
• Connect the drain hose properly and
ensure that it is not kinked and is free of
obstacles.
• Place the hose outlet over a drain or
bucket and ensure that the water can flow
out of the unit without obstruction.
• The end of the hose must not be immersed
in water.
To avoid spilling water:
• Since the negative pressure of the drain pan for condensate is high, lay the drain hose
downwards towards the floor. The angle of inclination should exceed 20 degrees.
• Straighten the hose to avoid creating a siphon.
5.0 CLEANING AND CARE INSTRUCTIONS
Cleaning the air filter (every two weeks)
Dust deposits on the filter and restricts air circulation. The restricted air circulation reduces the
system's efficiency and may cause damage to the system in the event of blockage.
The air filter must be cleaned regularly. The air filter can be removed for easy cleaning. Do not
use the unit without an air filter, as the evaporator may be contaminated.
Switch off the unit.
•
Pull the mains plug.
•
Remove the filter screen from the unit.
•
Use a vacuum cleaner to suck dust from the filter.
•
Turn the filter over and rinse the air filter under running water. Allow the water to flow through
•
the filter in the opposite direction to the airflow. Set the filter to one side and allow it to air-
dry completely before reinstalling it.
Fig. 1.
Switch off the unit and
remove the two air filters.
Warning!
The surface of the evaporator must not be touched with bare hands, as this can result in
damage to the slats and injury.
Remove the rubber sealing
cap
Hose
for
drainage
33
continuous
Fig. 2.
Rinse the air filter
under running water.
www.DEUBAXXL.de