Publicité
Les langues disponibles
Les langues disponibles
OSCILLATION ADJUSTMENT
1
Use the oscillation
control 10
forward movement of the saw blade
during retraction.
INCLINATION ADJUSTMENT
1
Retract the vacuum adaptor 11.
Caution! Make sure the tool is
switched off and unplugged.
3
Set the desired inclination. Markings on
the foot
plate 8
give a rough impression
of the deviation from a vertical cut.
SAW BLADE REPLACEMENT
1
Always use a blade that suits your
workpiece. Rotate the blade clamp
counter clockwise.
Caution! The saw blade is sharp.
Make sure the tool is switched off
and unplugged and wear protective gloves.
3
Rotate the blade clamp
5
clockwise. Insert the blade to it with
the teeth facing forward and release
the blade clamp 5.
122
EN
to set the
2
Oscillation settings:
7
0 no movement: for thin workpieces,
narrow curves and precise cuts
I for hard materials
II for thick workpieces
III for fast cuts in soft materials
2
Loosen the cylinder head bolt at the
bottom of the footplate
clockwise.
4
Fix the bolt at the bottom of the foot-
8
plate
clockwise. Re-attach the vacu-
um adaptor
11
until it clicks into place.
2
Carefully pull out the saw blade
5
the blade clamp
5
and release the
blade clamp 5.
counter
4
Make sure, that the blade is centred
in the groove of the guide roller 9, and
that the saw blade
7
is securely fixed.
1
1
8
counter-
3
7
from
1
3
2
2
4
2
4
Publicité
