Publicité
Les langues disponibles
Les langues disponibles
Filter replacement instructions
1. On average, HEPA filter needs to be cleaned every 360
hours and replaced every 2160 hours. Filter life will vary
depending on air quality and usage.
2. Turn off and unplug the air purifier before attempting to
replace the filter.
3. Press the tab of filter cover to open the cover and then
remove the HEPA filter.
4. Discard the old HEPA filter and do not attempt to clean.
And then install a new HEPA filter well in position, make
sure that the primarily efficient filter shall be pointed
outwards.
5. Replace the filter cover back in position.
Device does not work.
No or decreased air flow
E11
E1
E5
E0
E2
Troubleshooting
Check if the device is plugged to the power supply.
Check if the device is turned on.
Check if filter is properly installed and the filter cover is firmly closed.
Check the filter status and clean or replace if necessary (too dirty).
Check to ensure nothing is blocking the air inlet and filtered air outlet.
Replace the HEPA filter if it has not been replaced periodically.
Ensure the plastic bag has been removed from the filter.
Error code interpretation
This appliance is out of speed or under over heating protection. After 10mins, re-plug in
the appliance and turn on it again.
The motor is faulty, please contact the authorized service center or partner for checking
and repairs.
The filter cover is not assembled properly, please re-assemble, then the appliance will
return to operation mode.
The filter is not assembled properly, please re-assemble, then the appliance will return to
operation mode.
The dust sensor or related circuit may be damaged, please contact the authorized service
center or partner for checking and repairs.
(Original instructions)
WARNING:
•
To clean the dust sensor carefully open the cover on the
rear side of the unit.
•
Use dry cloth or cotton swab to carefully wipe the sensor.
Do not apply pressure while cleaning to avoid damage to
the sensor.
ENGLISH
7
Publicité
