Black & Decker AP3560-B5 Traduction Des Instructions D'origine page 6

ENGLISH
Pre-Operating instructions
1. Carefully unpack your air purifier.
2. Select a firm level place where there are no obstructions
to the air inlet or filtered air outlet.
3. Press the tab of filter cover, and then pull the filter cover
backwards to remove it.
4. Detach the HEPA filter and then unpack the PE bag
carefully.
5. Replace the HEPA filter back in position, make sure that
the primarily-efficient filter shall be pointed outwards.
6. Replace the filter cover back in position.
Operating instructions
Important:
• Remove all PE bags from filters before use.
• Always place the unit in an area such that there is
enough clear space around the unit to avoid blocking of
air suction .
• Avoid blocking filtered area outlet (top grill) to facilitate
purified air circulation in the room.
To operate your air purifier:
1. Plug into a electrical outlet of 220V~240/50~60Hz, two
beeps "Bi-Bi" can be heard.
2. Press down the ON/OFF button, one beep "Bi" can be
heard and its corresponding LED turns on, the light ring
will illuminate in different color according to the current
air quality and the display will show the value of PM2.5.
3. The air purifier starts to run under the default speed
(AUTO setting). If you want to select other settings, you
can press " SPEED/AUTO" button to select your desired
speed setting. There are five speed settings including
Speed 1, Speed 2, Speed 3, Speed 4 and AUTO for
selection. After select, its corresponding LED will turn
on.
4. You can activate the timer after turn on the air purifier
and select your required speed setting by following the
operation as below: press down "TIMER" button on the
control panel, one beep "Bi" can be heard. There are 4
settings including 2H, 4H, 6H and 8H for selection. After
select your required timing, its corresponding LED turns
on. When the timer expires, the air purifier will power off
automatically and the LED will extinguish.
5. To activate the "Sleep" mode, press the "SLEEP/LOCK"
button once to make the appliance enter into the "Sleep"
mode, and then the corresponding icon of "Sleep" mode
shown in the display illuminates.
6. To activate the "Child lock" function, hold and press the
"SLEEP/LOCK" button for 3 seconds to make the
6
(Original instructions)
appliance enter into the locking condition, and then the
corresponding icon of "Child lock" shown in the display
illuminates.
7. To make the appliance enter into "Night light" mode,
press the "NIGHT LIGHT" button once , and then the
display and the light ring turn off and the middle part of
the display shows "-".
8. To release negative ions into the filtered air, press the
"IONIZER" button once, then the negative ions will be
released into outgoing filtered air to help the air
purification process, and the icon of ionizer shown in the
display will illuminate.
9. To activate the "UV lamp" function to sterilize, press the
"UV" button on the control panel to turn on the UV lamp
and the icon of "UV" shown in the display will
illuminate.The icon of "UV" shown in the display will
illuminate in blue solidly to remind the user to eplace the
UV lamp if the appliance has been operated for up to
7300 hours cumulatively.
10. If you want to make the air purifier stop running, just need
to press " ON/OFF" button once. And the air purifier will
stop working after hearing one beep "Bi".
Mains plug replacement
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal of the new
plug.
• Connect the blue lead to the neutral terminal.
• If the product is class l (earthed), connect the green /
yellow lead to the earth terminal.
Warning! If your product is class ll double insulated (only 2
wires in the cord set), no connection is to be made to the
earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Any replacement fuse must be of the same rating as the
original fuse supplied with the product.
Cleaning and maintenance
1. Turn the air purifier off and unplug it before cleaning.
2. The outside of the air purifier can be cleaned with a soft,
clean and dampened cloth.
3. The filtered air outlet and the filter cover can be cleaned
of dust with a small, soft brush.
4. If you wish to clean the inside of the air purifier, please
only use a dry, soft cloth to wipe it down.
5. Do not wash the HEPA filter.
WARNING: Do not allow moisture to come in contact with the
main body of the air purifier.