EINHELL TP-MG 18 Li BL Instructions D'origine page 16

3. Proper use
The equipment is suitable for sanding/grinding
small areas. For sanding/grinding larger areas the
vacuum extractor, which is available as an acces-
sory (see 7.3), must be used.
The equipment is designed for the sanding/grin-
ding of wood, iron, plastic and similar materials
using the appropriate abrasive paper. Furthermo-
re, the equipment is intended for sawing wood,
plastic and similar materials, as well as scraping
off glued carpets, fi lling compound residues, old
paint and similar applications.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
4. Technical data
Motor power supply: ............................... 18 V DC
Idling speed: ...........................11000-20000 min
Sanding/grinding area: ............. 90 x 90 x 90 mm
Oscillation angle: ...........................................3.2°
Weight: .......................................................1.1 kg
Important!
The equipment is supplied without rechargeable
batteries and without a charger and is allowed to
be used only with the lithium-ion batteries of the
Power X-Change series!
The lithium-ion batteries of the Power X-Change
series are allowed to be charged only with Power-
X chargers.
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
L sound pressure level ........................ 79 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 87 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Anl_TP_MG_18_Li_BL_SPK13.indb 16 Anl_TP_MG_18_Li_BL_SPK13.indb 16
GB
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Handle
Vibration emission value a
K uncertainty = 1.5 m/s
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
-1
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
- 16 -
= 8.648 m/s 2
h
2
06.09.2023 09:58:06 06.09.2023 09:58:06