Publicité
Les langues disponibles
Les langues disponibles
9123969
Retighten the knobs and reinsert the pins once you have the correct
configuration.
4.
Lock the casters to prevent movement.
5.
Lower the vehicle frame onto the cart. Do not disengage the lift or
crane yet.
6.
Check that the vehicle has made full contact with each corner support
pad. Raise or lower a corner pad to contact the frame. If it cannot
reach, then adjust the corner block (#7).
a.
Lower the support pad.
b.
Remove the long locking pin (#9) holding the corner block (#7).
Loosen the knob as well.
c.
Raise the corner block until the bolt holes align. Tighten the knob
to hold the corner block. Insert the long locking pin through the
corner frame and block.
d.
Raise the support pad until touches the frame.
7.
Disengage the crane or lift.
8.
Secure the vehicle frame to the cart with straps or chains.
9.
Unlock the casters and move the frame to the work area.
10. Lock all casters in place once the cart is in position.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Keep the tool clean, dry and free from oil/grease at all times.
4.
Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
6
Heavy Duty Autobody Cart
For technical questions call 1-800-665-8685
V1.0
Publicité
