Accelerator Pedal - RCM Slalom Manuel D'utilisation Et D'entretien

11) Main brush adjusting screw
If the main brush is worn or leaves lines of dirt, adjust it with the properly screw.
The main brush should just touch the f oor, leaving a "A" trace 3 cm wide when it rotates (f g.2 ).
- loosen the screw and move it up or down through the slotted hole to adjust the trace.
- tighten the screw when the adjusting is completed.
Warning!
Never sweep up string, wire, etc., which can become entangled in the brush and damage the bristles.

12) Accelerator pedal

Controls the transfer of the machine.
Select the drive direction and press the pedal as described at the point 7 .
!
Warning!
The drive selection control is activated only with operator seated correctly on board.
13) Side brush lifting/lowering knob.
During the transfer or when the machine is at rest, lift the side brush as follows:
- To lift the brush place the knob in position "S" and tighten it (clockwise) to lock the side brush.
During the work, lower the side brush as follows:
- Loosen (anticlockwise) the knob and place it in position "A" to lower the brush.
A. Brush LOWERED
S. Brush LIFTED
!
Warning!
When the sweeper is at rest, the side brush must always be lifted above the ground to avoid deformations (bending
of the brush's bristles).
14) Side brush adjusting screw
If the side brush is worn adjust it with the properly screw.
The side brush should just touch the f oor, leaving a "B" trace (see f g.2 ).
- loosen the screw and move it up or down through the slotted hole to adjust the trace.
- tighten the screw when the adjusting is completed.
15 - 16) Main brush belt tighteners
The tighteners adjusting the tension of the driving belts for the main brush ( see "MAIN BRUSH FIG.3 - adjusting
the belt tension)
ENGLISH
35