JVC UX-C25DA Mode D'emploi page 27

Basic functions
Turning on the system: Press the button
"HELLO" appears in the display.
Switch off in standby: Press the button
"GOOD BYE" appears in the display and the device switches in standby mode.
Volume control
On the remote control: Press the VOL+ button to raise the volume or press the VOL- button to
lower it.
On the main device: Turn the volume control to raise or lower volume.
At minimal volume, "VOL MIN" will be briefly shown in the display and at maximal volume,
"VOL MAX will be displayed.
Temporary turning off volume: Press the button
flashes on the display. When the button is pressed again, the original volumes will be reinstated.
Equalizer
On the remote control: Press the EQ button to retrieve settings one after the other:
JAZZ -> CLASSIC -> ROCK -> POP -> FLAT
Using CD and USB
Preparation
Insert a CD
1. Press the button on the main device or on the remote control to open the CD compartment
2. Lay a CD in the CD compartment with the printed side facing upwards
3. Press the button on the main device or on the remote control to close the CD compartment
To remove a CD
1. Press the button on the main device or on the remote control to open the CD compartment
2. Carefully remove the CD from the CD compartment
3. Press the button on the main device or on the remote control to close the CD compartment
on the remote control or on the main device.
on the remote control or on the main device.
on the remote control for this. "MUTE"
9