JVC UX-C25DAB Manuel D'utilisation page 26

Before initial operation
Unpacking
Carefully unpack the device and take care that all accessories are present:
Operating manual
Notes about reading the manual
Most functions can be controlled using the remote control.
Preparation of the remote control
• Insert the battery into the remote control, taking care that it is in the correct polarity (+ and -).
• The battery provided is intended for functional checking and can have a short service life.
• If the operating range of the remote control decreases, replace the old battery with a new one.
• If you expose the remote control sensor to direct sunlight or the light from high frequency
fluorescent lamps, this may lead to malfunctions. In such situations, you should set up the system
at another place to avoid such malfunctions.
Connecting
• Carefully unpack the device and take care that all accessories are present.
• Connect the left and right speaker with the relevant
(Speaker Out) port on the side of the device.
• Connect the mains plug firmly to an AC outlet. As the mains plug is used as the
disconnect device, the AC outlet shall be kept readily accessible.
DAB+ / FM antenna port
1. Connect the cable to the [AERIAL] jack.
2. Find a place where the best reception is achieved.
3. Fix the antenna in position.
• The antenna provided with the system is a simple dipole antenna. The use of a (commercially available)
outdoor antenna is recommended for stable signal reception.
To connect an outdoor antenna, first take off the indoor antenna.
• FM/DAB+ reception cannot be guaranteed when receiving radio transmissions from the cable network.
6
Remote control FM/DAB antenna R03/AAA 1.5 Volt Battery