Troubleshooting; Cleaning The Gas Barbecue; Exterior Surfaces - Profi Cook PC-GG 1059 Mode D'emploi

Table des Matières

Les langues disponibles

Switching on the side burner

You can operate the side burner separately.

1. Open the cover of the side burner before you ignite it.

2. Press the adjustable knob of the burner and turn it anticlockwise to the HI position. At the same time, you will hear a CLICK. The burner will ignite. If the

burner does not ignite, repeat this step

3 If the burner still does not ignite, wait 5 minutes and repeat step 2

4. If the burner does not ignite, ignite the burner with a long match. Contact your dealer or gas technician in order to resolve the fault with the ignition.

5. Regulate the heat by turning the adjustable knob to any setting of your choice between the HI and LOW setting.

6. In order to shut down the burner, turn the adjustment knob to the 12 o'clock position (OFF).

7. In order to shut down the entire barbecue, close the valve on the gas cylinder and turn all the adjustment knobs to the 12 o'clock position (OFF).

Tips for barbecue cooking

The gas barbecue is a multifunctional appliance. With the hood closed, you can use your gas barbecue like an oven.

• You don't have to only barbecue meat, fish, vegetables and fruit, you can also cook them.

• With a closed hood, the temperature should not be allowed to get too high. A low temperature results in gentle cooking of the barbecue food.

• Monitor the temperature on the thermometer and if necessary, adjust it.

• The following applies as a rule of thumb: If smoke emerges from a closed hood, the temperature is too high!

Malfunctions are often just caused due to minor problems. Before contacting our customer service, please check the table below:

Problem

Possible cause

The burners cannot be ignited

1 Gas cylinder is empty

by the ignition system.

2 The regulator is damaged

3 The burner is blocked

4. The gas jets or hose is blocked

5 The electrode wiring is loose or separated from the elec-

6. The electrode or cable is damaged, faulty switch ignition

Burner does not ignite with a

1. Gas cylinder is empty

lit match

2 The regulator is damaged

3 The burner is blocked

4. The gas jets or hose is blocked

No yellow flame or back cou-

1. Gas cylinder is too small

pling (fire in the burner line –

2. Burner blocked (insect nest?)

hissing or bubbling noise)

3. The gas jets or hose is blocked

4 Draft

WARNING: HOT SURFACES

Before cleaning, wait until the gas barbecue has cooled down sufficiently.

WARNING: RISK OF FIRE AND EXPLOSION

• Before cleaning the gas barbecue, remove the gas cylinder.

• Do not use any flammable detergents.

CAUTION:

• Do not use a wire brush or other abrasive utensils for cleaning.

• Do not use any oven cleaners. Oven cleaner attacks painted surfaces.

• Clean the barbecue after each use!

NOTE:

If you allow both burners to burn at full power for approx. 15 minutes without food, the residual deposits will be burn away completely.

Exterior surfaces

• Use mild detergents, caustic soda and hot water.

• Mild abrasive agents can be used for stubborn stains.

• Following this, rinse thoroughly with water.