Atag KA2092DLUU/A02 Mode D'emploi page 30

Door removal
Electric Shock Hazard
Warning
Disconnect electrical supply to refrigerator before installing.
Failure to do so could result in death or serious injury.
If your access door is too narrow for the
refrigerator to pass through, remove the
refrigerator door and pass the refrigerator laterally.
Remove lower
Remove the lower cover by lifting upward, and
cover and
remove clip, and then pull up the feed water tube
while pressing area
then feed water
right.
tube
Remove the
1) Removing the hinge cover by loosening the
freezer
compartment
door
2) Remove the keeper by rotating it counter
3) Remove the freezer compartment door by
Remove the
1) Loosen the hinge cover screws and remove
refrigerator
door
2) Remove keeper by rotating it clockwise ( )
3) Remove the refrigerator compartment door
30
shown in the figure to the
NOTE
If a tube end is deformed or abraded, cut the part away.
•
screws. Separate all connection wires except
for the earth line after.
clockwise ( ) and then lifting the upper
hinge up ( ).
NOTE
• When removing the upper hinge, be careful that the door does not fall forwards .
lifting it upward. This time, the door should
be lifted enough for the feed water pipe tube
to be completely pulled out.
NOTE
• Move the refrigerator compartment door passing through the access door and lay
it down, but be careful not to damage the feed water pipe tube.
the cover. Remove connection wire, if any,
except for the earth line.
and then remove the upper hinge by lifting
it up ( ).
by lifting it up.
Installation
Feed water tube
Hinge
cover
Upper hinge
Keeper
Lower hinge
Connection
wires
Upper hinge
Lower hinge
Lower cover
Connection
wires
Earth line
Upper hinge
Keeper