Silverline 300316 Mode D'emploi page 8

Masquer les pouces Voir aussi pour 300316:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
GB
Troubleshooting
Problem
The heat shuts off but the fan
stays on
The heating element is smoking
slightly and there is a burning odour
The heating element is not glowing
bright red like other heaters
There is no heat or air flow coming
from the heater
The fan maintains the same speed
when the settings are changed
8
Possible cause
The fan is designed to run continuously while the heater is
operating; the thermostat is designed to switch on and off to
maintain the set temperature
The steel element's protection oil coating is burning off
The heating element is made from stainless steel and will
not glow bright red like other heaters
The power to the heater has been shut off
The desired room temperature set on the thermostat has
been reached
The area directly in front of the heater is not being heated,
but the room generally is being heated
The fan maintains the same speed when the Thermostat Dial
(6) and the Mode Selector Dial (5) are being changed
The Mode Selector Dial (5) has been turned to the OFF
position but the fan is still running
Solution
The heater is operating correctly
If this is the first time the heater has been used, this is normal and the amount of
smoke emissions will diminish in a short time. If it is a constant stream of smoke
and the heater has been used several times, immediately switch the heater OFF
and contact an authorised Silverline service centre
The heater is operating correctly
Check the power being supplied to the heater. Unplug the heater and try a different
socket. If the heater does not work, contact an authorised Silverline service centre
The thermostat is working correctly and is designed to switch on and off to
maintain the set room temperature. The heater is operating correctly
The heater is operating correctly. The thermostat will switch on and off to maintain
the set temperature
The heater is operating correctly. The fan is designed to maintain the same speed
when the controls are changed
Switch off power to the heater and contact an authorised Silverline service centre

Publicité

Table des Matières
loading

Table des Matières