AKG MicroMic C 416 III Série Mode D'emploi page 25

3 Using Your Microphone
5 3 pan-head bolts and nuts (3 x 30mm)
6 Elastic adhesive putty
1. Fix the H 416 installation plate on your instru-
ment or speaker cabinet in one of the following
ways:
a) Using screws:
• Depending on the material and thickness of the
installation surface, use the 13-mm (0.5-in.) fil-
lister head self-tapping screws or the 30-mm
(1.2-in.) pan-head bolts and nuts.
Be sure to tighten the screws without squeez-
ing the rubber eyelets.
The rubber eyelets provide a shock mount for the
microphone. These eyelets together with the
elastomer damper incorporated in the gooseneck
effectively suppress the transmission of mechani-
cal noise. Squeezing the rubber eyelets would de-
stroy their effectiveness as shock mounts.
3.2.1 Snap-on
Mounting
Fig. 6: Screwing
down the H 416.
Refer to fig. 6.
Important!
25