AKG MicroMic C 416 III Série Mode D'emploi page 20

1 Description
fore feedback, and good rejection of spillover from
nearby instruments.
The gooseneck uses a special shock mount that
makes the microphone highly insensitive to me-
chanical noise from the instrument or speaker.
1.6 Versions The C 416
C 416 PP • For 9 to 52 V universal phantom power. 10-ft.
III
(3-m) permanently attached connecting cable
with phantom power adapter with integrated
3-pin XLR connector.
C 416 L • For use with the B 29 L battery power supply,
III
MPA III L phantom power adapter, or
AKG.WIRELESS bodypack transmitters. 5-ft.
(1.5-m) permanently attached connecting ca-
ble with 3-pin mini XLR connector
2 Interfacing
2.1 Introduction The C 416
fore needs a power supply.
Important! Using any power supply other than those
recommended by AKG may damage your
microphone and will void the warranty.
2.2 C 416 PP 1. Connect the phantom power adapter (1) on the
III
2.2.1 Connecting microphone cable to a balanced XLR micro-
to Balanced phone input with phantom power.
Inputs 2. Switch the phantom power on. (Refer to the in-
Refer to fig. 1. struction manual of the unit to which you
connected your microphone.)
20
III is available in two versions:
is a condenser microphone and there-
III