Publicité
Les langues disponibles
Les langues disponibles
Change the Program...
Premise:
1. A cycle that is underway can only be modified if it has only
been running for a short time. Otherwise, the detergent
may have already been released, and the appliance may
have already drained the wash water. If this is the case, the
detergent dispenser must be refilled (see the section entitled
"Loading the Detergent" ).
2. Open the door, the machine will be in standby state, press
the program button more than 3s then you can change the
GB
program to the desired cycle setting (see the section entitled
"Starting a wash cycle..." ).
The front indicator show the state of dishwasher:
a).blue light with blinking: running;
b).blue light without blinking: pause;
c).no light: stand by
NOTE:
If you open the door during a wash cycle, the machine will pause.
The program light will stop blinking and the buzzer will mooing
every minute unless you close the door. After you close the door,
the machine will keep on working.
IF Your model has broken remember function, the machine will
go on to finish the selected program after the power cut.
94
Forgot to Add a Dish ?
A forgotten dish can be added any time before the detergent cup
opens.
1. Open the door a little.
2. After the spray arms stop working, you can open the door
completely.
3. Add forgotten dishes.
4. Close the door.
5. The dishwasher will run.
At the end of the Wash Cycle
When the working cycle has finished, the buzzer of the
dishwasher will sound for 8 seconds, then stop. Turn off the
appliance using the Power switch button, shut off the water
supply and open the door of the dishwasher. Wait for a few
minutes before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
Front indicators are off, only in this case the programme has
ended.
1. Switch off the dishwasher by pressing the Power button.
2. Turn off the water tap!
GB
95
Publicité
