Atag CX4692D/A13 Manuel D'utilisation page 137

INITIAL USE
Setting the time
TIME l HOUR
11
12
13
1. Turn the selection knob and select the hours.
2. Confirm this setting by pressing the right navigation key or by
pressing the selection knob.
3. Turn the selection knob and select the minutes.
4. Confirm this setting by pressing the confirm key.
All the start-up settings are set and the appliance will show the
standby display.
The language, time and date can be adjusted in the settings menu (see
'Settings menu' chapter). The settings menu can be opened from the
start display via the 'Plus' menu.
Standby display
The standby display will show the time, date, cavity temperature (if
this is higher than 80 °C) and the timer (if set). The appliance goes to
standby mode after:
• Turning the function knob to 0 ('off' position).
• Pressing the stop key multiple times (deeper in the menu).
Off mode
• Default the appliance will shut down after no action for a set time of
30 minutes.
• Press and hold the stop key to shut down the appliance manually.
Switching the appliance on
• Press and hold the stop key to switch on the appliance.
• The appliance can also be switched on by turning the function knob
to a function.
:
03 05 2015
• •
12 : 00
00
EN 13