FITFIU FITNESS MC-400 Manuel D'instructions page 56

ASSEMBLY
STEP 1.
Remove all parts from the carton and place them on a firm, flat surface. Remove all packing materials. Using the
screwdriver, remove (turn to the left) the 2 screws (8, shown in step 3) that secure the plastic cover (7, shown in step
3) to each side of the unit.
STEP 2.
With the unit flat, lift the handle assembly (2) so that it is upright, then secure the handle columns to the unit base (1).
Use the hexagon socket wrench and M8*45 screws (3) to fix and tighten it with the M8 nut. Use the M8*22 screw (6)
to fix the column to the base. Clamp the left and right columns, use inner hex wrench and M8*25 screw to lock the
console frame on the columns.
2
STEP 3.
Place each plastic cover (7) in position and attach it to the equipment using the previously removed screws (8) (turn
clockwise).
STEP 4.
Rotate the console (9) so that it is almost horizontal, and then fix it to the handle columns with 2 M8x22 screws (6).
Tighten the screws (turn clockwise) with the Allen key.
STEP 5
Prepare the bottom rail of the accessory bar (10) by sliding 2 pieces of tube padding (11), followed by a tube joint cover
(12) on each end. The joint covers should be inserted into the small end first. For the top rail of the accessory bar, slide
a tube joint cover on each end, small ends first.
5
7
9
8
56
3
1
6
6