FLAEM Neb-Aid P0603EM F400 Mode D'emploi page 19

EQUIPMENT AND MATERIAL INFORMATION
The equipment includes:
Compressor unit - Model: P0604EM F400
A1 - Switch
A2 - Air intake
A -
A3 - Air filter
A4 - Nebuliser holder
A5 - Carrying handle
A6 - Power cable
Nebuliser and accessories - Model: RF7-1
B1 -Connecting tube (compressor/nebuliser unit)
B2 - RF7 Dual Speed Nebuliser
B2.1 - Lower part
B2.2 - Nozzle
B2.3 - Upper part
B2.4 - Speed selector
B3 - Mouthpiece
B -
B4 - Adult SoftTouch mask
e
B5 - Pediatric SoftTouch mask
B6 - Pediatric nasal
B7 - Manual nebulization control
IMPORTANT NOTE: There is an identification label on the packaging, remove it and affix it in
the spaces provided on page 2. When replacing the Nebuliser and accessories, perform the
same procedure.
C -
Convenient, roomy carrying bag
OPERATING INSTRUCTIONS
Before each use, wash your hands thoroughly and clean your appliance as described in the
section "HYGIENE PREPARATION". During application, it is recommended to adequately protect
oneself from drips. This appliance is suitable for the administration of medicinal substances
(solutions and suspensions), for which aerosol administration is envisaged; such substances
must in any case be prescribed by a doctor. In the case of substances that are too dense, dilution
with suitable saline solution may be necessary, as prescribed by a doctor.
1. Insert the plug of the power cable (A6) into a mains socket corresponding to the voltage of the ap-
pliance. It must be positioned in such a way that disconnection from the power grid is not difficult.
2. Insert the nozzle (B2.2) in the upper part (B2.3) pressing as shown by the 2 arrows in the "Connec-
tion diagram" in point B2. Insert the Speed selector (B2.4) in the upper part (B2.3) as shown in the
"Connection diagram" in point B2. Pour the medication prescribed by the doctor into the lower part
e
(B2.1). Close the nebuliser by turning the upper part (B2.3) clockwise.
er
3. Connect the accessories as shown in the 'Connection Diagram' on the cover.
4. Sit comfortably while holding the nebuliser in your hand, place
the mouthpiece to your mouth or use a nasal piece (if provided) or
mask. If you use the mask accessory, place it on your face as shown
in the figure (with or without the use of the elastic band).
5. Switch on the device by pressing the switch (A1) and inhale and
exhale deeply; after inhaling, it is recommended to hold your
breath for a moment so that the inhaled aerosol droplets can
settle. Then exhale slowly.
6. When the application is finished, switch off the device and discon-
nect it from the mains.
ATTENTION: If, after the therapy session, an obvious deposit of moisture forms inside the tube (B1),
detach the tube from the nebuliser and dry it with the ventilation of the compressor itself; this action
prevents possible mould growth inside the tube.
Information on materials
Polypropylene
Polypropylene +
Thermoplastic Elastomers
Polypropylene
19