MINN KOTA MICRO REMOTE Manuel Du Propriétaire page 5

PAIRING THE MICRO REMOTE TO YOUR CONTROLLER
The controller is located in the Control Head on your Minn Kota trolling motor with Advanced GPS Navigation and may pair up to 5
remotes. These five remotes can be a combination of standard remotes and micro remotes. Any additional remotes can be paired using
the following steps. Once the maximum number of remotes have been paired, the controller will start replacing the oldest paired remote
in memory with the new remote.
1
a. Power up the trolling motor.
b. Locate the Pair
Control Head.
c. Push and hold the Pair
tone will be emitted from the
Control Head.
Make sure the remote stays within range of
NOTICE:
the Control Head during the pairing process.
2
d. While holding the Pair
Head, push and hold the Max Speed
AutoPilot
When the remote is being paired to the
NOTICE:
Controller, the Max Speed
buttons need to be held down simultaneously.
Make sure to also hold the Pair
Control Head to successfully pair the remote to
the controller.
e. Once successfully paired, 3 longer beeps will be
emitted from the Control Head and the remote will
be paired.
©2024 Johnson Outdoors Marine Electronics, Inc.
PAIRING THE MICRO REMOTE TO YOUR CONTROLLER
button at the top of the
PAIR
button down. A consistent
PAIR
button on the Control
PAIR
and
buttons on the remote simultaneously.
and the AutoPilot
button on the
PAIR
Pair Pair
Button Button
Max Speed Max Speed
A remote can be paired to one controller at a time.
NOTICE:
A controller can have multiple remotes paired to it.
AutoPilot AutoPilot
minnkota.johnsonoutdoors.com | 5