MINN KOTA MICRO REMOTE Guide De Référence Rapide

Compatible with all Bluetooth
REMOTE
Max
Speed
Decrease
Speed
Prop On/Off
Steer Left
NOTICE: If your motor has Spot-Lock Jog enabled, the Speed
Down (backwards), Speed Up
and Steer Left buttons function change to Jog the boat
while in Spot-Lock.
PAIRING
Pairing the Micro Remote to your Controller
The controller is located in the Control Head on your Minn Kota trolling
motor with Advanced GPS Navigation and may pair up to 5 remotes.
These five remotes can be a combination of standard remotes and
micro remotes. Any additional remotes can be paired using the following
steps. Once the maximum number of remotes have been paired, the
controller will start replacing the oldest paired remote in memory with
the new remote.
1. Power up the trolling motor.
2. Locate the Pair button at the top of the Control Head.
PAIR
3. Push and hold the Pair
emitted from the Control Head.
NOTICE: Make sure the remote stays within range of the
Control Head during the pairing process.
4. While holding the Pair
hold the Max Speed
remote simultaneously.
©2023 Johnson Outdoors Marine Electronics, Inc.
®
enabled Minn Kota GPS Navigation Systems only.
(forward), Steer Right
button down. A consistent tone will be
PAIR
button on the Control Head, push and
PAIR
button and AutoPilot button on the
MANUAL CONTROL BUTTONS
AutoPilot
Spot-Lock
Increase
Speed
Steer Right
NAVIGATION BUTTONS
NOTICE:
the Max Speed
to be held down simultaneously. Make sure to also hold the
Pair
remote to the controller.
5. Once successfully paired, 3 longer beeps will be emitted from the
Control Head and the remote will be paired.
NOTICE:
controller can have multiple remotes paired to it.
MICRO REMOTE
QUICK REFERENCE GUIDE
Speed Down & Speed Up
Press to decrease or increase motor speed.
Prop On/Off
Pressing this button will turn the Prop on and off.
Steer Left & Steer Right
Press to steer the motor to the left or to the right.
Max Speed
Bypasses the current motor speed to speed 10.
Double press to engage. Single press to disengage.
Spot-Lock
Press to enable Spot-Lock. When Spot-Lock is enabled
from the Micro Remote, use either the fully functioning
standard remote or the fish finder if you want to save it.
AutoPilot
Press to enable AutoPilot. The selection between Heading
Lock and Course Lock must be made from either the fully
functioning standard remote or the fish finder.
When the remote is being paired to the Controller,
button and the AutoPilot
button on the Control Head to successfully pair the
PAIR
A remote can be paired to one controller at a time. A
Scan to view the complete Micro Remote Owner's
Manual online. The Owner's Manual is available
at minnkota.johnsonoutdoors.com
information on compatibility, safety considerations,
compliance, maintenance, parts and more.
button need
and includes
minnkota.johnsonoutdoors.com