NEFF KA1903I20 Notice D'utilisation Et De Montage page 55

Cleaning the appliance
m
Caution
Do not use gritty, acidic or chlorine-based cleaning
■
agents or solvents.
Do not use abrasive cleaning pads or sponges that
■
may scratch surfaces. This may lead to corrosion of
the metallic surfaces.
Never clean the shelves or containers in the
■
dishwasher. The parts may warp.
Proceed as follows:
1. Switch off the appliance before cleaning.
2. Unplug the appliance from the mains or switch off
the circuit-breaker.
3. Take out the food and store it in a cool place. Place
an ice block (if you have one) on the food.
4. Wait until the layer of frost has thawed out.
5. Clean the appliance with a soft cloth, lukewarm
water, and a little pH-neutral washing-up liquid. The
washing-up liquid solution must not be allowed to
get into the lights or run into the evaporation tray
through the drain hole.
6. Only wipe the door seal with clean water and then
rub it until it is dry.
7. After cleaning, reconnect the appliance to the mains
and switch it on.
8. Put the food back in.
Fittings
All the variable components of the appliance can be
removed for cleaning (see section headed Fittings).
Ice-cube container
If no ice-cubes are dispensed for an extended period,
the ice cubes in the container shrink, taste stale and
stick together. Therefore, the ice-cube container should
be cleaned regularly.
m
Caution
The ice-cube container is heavy when it is full.
1. Press and hold the "Ice cubes/Crushed ice" button
for 3 seconds.
2. Pull out the ice-cube container.
3. Empty the ice-cube container and clean it.
4. Push the ice-cube container all the way back on the
runners until it snaps into place.
Water spillage tray
Spilt water collects in the water spillage tray.
1. To empty and clean it, remove the strainer.
2. Clean the water spillage tray with a sponge or
absorbent cloth.
3. Refit the strainer.
Smells
If you notice unpleasant smells:
1. Unplug the appliance from the mains or switch off
the circuit-breaker.
2. Remove all food from the appliance.
3. Clean the inside of the appliance (see section
headed Cleaning the appliance).
4. Clean all packaging.
5. Pack strongly smelling food in air-tight containers to
prevent odours.
6. Switch on the appliance again.
7. Arrange the food.
8. After 24 hours, check again to see if the smells
have reappeared.
Lighting (LED)
Your appliance is equipped with a maintenance-free
LED light.
Any repair work on the lighting must only be carried out
by the after-sales service or authorised experts.
en
55