NEFF KA1903I20 Notice D'utilisation Et De Montage page 35

Floor surface
The floor at the installation site must not give. Reinforce
the floor if necessary.
The appliance is very heavy. The weight when empty is
detailed in the table below.
Version with ice and water
dispenser
Version with ice and water
dispenser and fresh food drawer
Version with ice and water
dispenser, fresh food drawer and
mini-bar
Wall clearance
If the appliance is positioned in the corner of a room or
a recess, minimum clearances (see the section headed
Installation dimensions) at the sides must be
maintained so that the appliance doors can be fully
opened.
If the depth of the adjacent kitchen fittings exceeds
65 cm, minimum clearances at the sides must be
maintained so that the full opening width of the doors
can be utilised (see section headed Door opening
angle).
Minimum clearance at rear
Fix the spacers supplied to the holes provided on the
rear of the appliance using the screws.
The spacers maintain the minimum clearance of
22 mm from the wall, thus providing adequate
ventilation.
107 kg
109 kg
111 kg
Observe the room temperature and
ventilation requirements
Room temperature
The appliance is designed for a certain climate class.
Depending on the climate class, the appliance can be
operated at the following ambient temperatures.
The climate class is specified on the rating plate.
Climate class Permissible room temperature
+10 °C to 32 °C
SN
+16 °C to 32 °C
N
+16 °C to 38 °C
ST
+16 °C to 43 °C
T
Note
The appliance is fully functional within the room
temperature limits of the specified climate class. If an
appliance in the SN climate class is operated at lower
ambient temperatures, damage to the appliance can be
excluded up to a temperature of +5 °C.
Ventilation
The heated air must be able to escape unimpeded.
Otherwise, the refrigerating unit has to work harder,
which increases the appliance's power consumption.
Therefore, never cover over or block the air vent.
en
35