Publicité
Les langues disponibles
Les langues disponibles
• Fix the charging base to the wall using
appropriate screws and plugs for the type
of wall, and weight of the appliance.
• Hang the appliance by placing the
opening of the vacuum base over the
hooks in the charging base.
Charging the battery
WARNING:
supplied charger.
• Before first use, the battery must be
charged for at least 5 hours.
• Place the appliance on the charging base (11)
whenever it is not in use as shown in Figure A.
WARNING:
to empty all contents and dry thoroughly if
needed to avoid damage to your appliance.
• Make sure the appliance is switched off.
The battery will not be charged when the
on/off switch (1) is in the on position.
NOTE: While charging, the charger may
become warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
WARNING: Do not charge the battery at
ambient temperatures below 50 °F or above
104 °F.
A
Switching on and off - Figure B
• To switch the appliance on, depress the
on/off button (1). The battery indicator
LED will illuminate and vacuum will begin
in the low-speed mode.
• Depress the button a second time to
engage the POWERBOOST mode. The
green LED will also illuminate, indicating
the vacuum is in the higher-speed mode.
• To switch the appliance off, depress the
button a third time.
For use only with the
Before charging, be sure
B
POWERBOOST mode
The green LED will illuminate when the
appliance is in POWERBOOST mode. The
vacuum will operate at a higher suction level
to pick up debris that requires more power.
Filter sensor (HHVJ320BMFS ONLY)
Whenever a filter is blocked and needs
cleaning, the red LED in the handle will
illuminate. Clean dust from filter (See
"Cleaning the Dust Bowl and Filter" section).
Nozzle / Accessories
• A crevice tool (4) is built into the nozzle
(3). Extend the crevice tool as shown in
Figure C, until it clicks in place.
• To shorten the crevice tool, depress the
crevice tool release button (5) as shown
in Figure D and slide the crevice tool into
the nozzle.
C
D
• A brush accessory is built into the nozzle
and can be flipped upwards for use as
shown in Figure E.
4
Publicité
