Publicité
Les langues disponibles
Les langues disponibles
position and tighten this fixing nut.
5) Speed adjustment: low speed, medium speed and high speed can be achieved by
turning the switch knob on the motor.
6) If the machine is selected to operate by misting mode, its misting magnitude can be
adjusted optionally between"OFF"and "ON".
7) The tank must be full filled with water before using the misting mode. The fan can
operate continually for 4 hours with the maximum misting volume. Re-fill the tank
to achieve the misting effect when it is short of water. Release the water after
cleaning the tank by unscrewing the knob on the bottom.
8) When using the handcart, please skid the front cartwheel to avoid glide naturally.
When moving the handcart, please loosen the front cartwheel lock. Before loosening
the front cartwheel lock, and please do not move it to avoid damage.
9) Please clean the water tank before using. Please take out the water pump before
cleaning the water tank
7. ASSEMBLY INSTRUCTIONS
DO NOT plug in the fan before assembly. This misting fan comes in 3 boxes. Carefully remove
all packing materials and retain for future storage/use. Make sure there is no residual foam
left in any of the components. Check all the components to avoid any parts missing, scratching,
or damaging during transportation. A screwdriver and a wrench will be required to assemble
this misting fan.
Step 1: Assembling the Stand Pole
a.Refer to diagram 1. Locate the tank cart and stand pole. Remove the four M8X25 bolts,
spring washer, flat washer, and nuts from the tank cart.
b.Position the stand pole on the tank cart and make the ball valve switch face the back. Align
the holes on the pole with the four holes on the cart.
c.Using the bolts, washers, and nuts removed in step a, screw the stand pole into the tank
cart. Make sure the stand pole is securely screwed onto the cart before proceeding to the
next step.
DIAGRAM 1
.
23
Publicité
