R&G FP0182BK Instructions De Montage page 2

NOTICE DE MONTAGE

Page | 4
Insérer une entretoise (S0115 – 11mm de long) dans le creux hexagonal du coté droit du moyeu avant.

Insérer un écrou et une rondelle sur l'axe (l'extrémité avec le filetage le plus court) et engagez l'écrou de façon à
ce que l'insert en plastique de l'écrou soit complètement engagé.

Passer l'axe (SB112) avec écrou et rondelle dans une bobine (B0442 M8) et dans l'entretoise tout juste insérée.

Placer l'entretoise restante (S0115 – 11mm de long) sur l'extrémité gauche de l'axe de façon à ce que
l'entretoise se place dans le creux hexagonal sur le moyeu avant puis glisser la bobine restante (B0442 M8) sur
l'axe.

Insérer la rondelle et l'écrou du kit sur le filetage puis serrer jusqu'à ce que les 2 écrous soient engagés dans le
nylon et que les longueurs dépassantes de chaque coté soient égales.

NE PAS TROP SERRER – Les écrous bloquent suffisamment.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not
diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or
warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it has
chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it
shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option
either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise than
in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or neglect. Other than
identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss
and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G
Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The
customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your
statutory rights and does not refer to faulty goods.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
OUTILS REQUIS

CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Jeu de clés 2x 13mm.
ISSUE 1 24/02/2016 (AR)
R&G Racing
www.rg-racing.com Email: info@rg-racing.com