Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
A clogged or dirty nozzle will result in excessive pump
pressure causing a pulsing sensation and/or excessive
vibration.
1. Turn off the pressure washer and turn off the water
supply. Release the residual pressure by squeezing
the gun's trigger.
2. Disconnect the pressure washer wand from the
surface cleaner.
3. Using a 14mm wrench (not provided) remove both
nozzles from the spray bar. (See Figure 11)
4. Using the nozzle cleaning tool, free any foreign
material clogging or restricting nozzle openings. (See
Figure 12)
5. Flush debris out of the nozzle. Direct the flow of water
through the nozzle backwards from the outside to the
inside.
6. Attach the wand back to the surface cleaner, set the
surface cleaner on a flat surface. Turn on the water
(DO NOT START THE PRESSURE WASHER) and
squeeze the trigger on the gun. Allow water to run
through the spray bar for approximately 30 seconds.
7. Reinstall the nozzles to the spray bar. Tighten securely.
Align the nozzle opening as shown in Figure 13.
NOTE: Make sure the groove on the face of the nozzle is
parallel to the spray bar.
NOTE: If the nozzles are not cleaned or aligned correctly
the spray bar will not rotate properly and it will not clean
as intended and may have a severe vibration.
WARNING:
If the surface cleaner experiences severe vibration,
STOP using immediately. Continuing to use the surface
cleaner may damage the shroud and result in serious
injury.
NOTE: If your spray pattern begins to change, it could
mean that the nozzles are worn and they need to be replaced.
NOTE: If the nozzles continue to get clogged, you may want to consider adding an in-line filter. You
can contact us at +1 (866) 870-9930 or email us at Support@surfacemaxx.com for more details.
Spray Bar
Figure 11
Figure 12
Spray Bar
Figure 13
8
Nozzle
Nozzle
Cleaning
Tool
Nozzle
Opening
Nozzle Opening
After tightening securely,
nozzle opening should be
pointed in same direction
as spray bar
www.surfacemaxx.com
Publicité
