SurfaceMaxx SGY-PWA1002 Manuel D'instructions page 5

INSTALLATION & PREPARATION
UNIT ASSEMBLY:
1. Place the lower handle assembly inside of the aluminum
support and line up the holes in the lower handle
assembly with the holes in the aluminum support.
Insert the bridge pin through outside hole of the
aluminum support and through the lower handle and
through the inside hole of the aluminum support. Attach
the clevis ring onto the bridge pin. Repeat this step on
the other side. (See Figure 2)
2. Attach upper handle and middle handle by lining up the
holes in the upper handle and middle handle. Push the
handle fixing bolt through the aligned hole and tighten.
(See Figure 3)
3. Attach the upper handle and middle handle assembly to
the lower handle assembly by lining up the holes in the
middle and lower handles. Push the handle fixing bolt
through the aligned hole and tighten. (See Figure 3)
4. Attach the inlet pressure hose to the handles. (See
Figure 4)
5. Take the short outlet pressure hose and starting with
the quick connect plug end slide it through the bottom of
the guide tube on the front of middle handle assembly.
(See Figure 5)
Lower Handle
Bridge
Pin
Figure 2
Upper
Handle
Middle
Handle
Figure 3
Quick Connect Plug
Figure 4
Quick
Connect
Plug
Outlet
Pressure
Hose
(Short)
Figure 5
5
Clevis Ring
Aluminum Support
Handle
Fixing
Bolt
Lower
Handle
Inlet
Pressure
Hose
Middle Handle
www.surfacemaxx.com