BENOIT SYSTEMS Mini Minotor 2.1 Mode D'emploi page 34

EN
TROUBLESHOOTING
Possible causes
Battery incorrectly locked in place
Joystick wire poorly connected
Red connectors damaged or loose
Battery fault
Fault in a component of the power add-on
Power add-on was turned on when the joystick
was not in the neutral position
The dashboard lights up normally but the power add-on doesn't work
Possible causes
The power add-on is in the disengaged position
The power setting is too low
Possible causes
Poor quality tyres
Tyres under-inflated
Insufficient pressure of the rollers on the tyres
Possible causes
The roller cover is touching the tyre
The bracket for the wheelchair wheel is loose
Possible causes
A manual brake of the wheelchair is on
A motor is faulty
Possible causes
Part of the wheelchair is touching a wheel
A motor is faulty
A bearing is faulty
A roller cover is touching the tyre
Possible causes
Incorrect adjustment of the ball joints
Distortion (following an impact for example)
SERVICING & MAINTENANCE MANUAL
The joystick dashboard is not lit or flashes
Rapid wear of the tyre treads
Tyre worn on the inner wall
The wheelchair goes in a circle
The power add-on is making noise
A clutch handle is not staying engaged
34
Solutions
Remove the battery slightly and re-engage it
Check the connection
Check the connectors are in good condition and the
contacts are in the correct position
Contact the dealer
Count the number of LEDs flashing and contact your
dealer
Switch off and turn on again
Solutions
Engage the two handles
Increase the power
Solutions
Fit recommended tyres
Inflate the tyres to 8 bar
Adjust the pressure
Solutions
Contact your dealer
Tighten this bracket correctly
Solutions
Release it
Contact your dealer
Solutions
Visually check the condition of the wheelchair
Contact your dealer
Contact your dealer
Contact your dealer
Solutions
Contact your dealer
Contact your dealer