BENOIT SYSTEMS Mini Minotor 2.1 Mode D'emploi page 32

THE
Disengage the power unit in a single
movement and so restore conventional
use of the wheelchair
find our explanatory videos on
CAUTION
It is important to follow the servicing and mainte-
nance programme for the equipment to keep it in
good condition.
SERVICING THE EQUIPMENT
• Before undertaking any cleaning, ensure the equipment is turned off.
• Clean the rollers and their housing regularly with a screwdriver.
• Once a week, run a vacuum cleaner around the motor, to remove all accumulated dust.
• Clean the entire power unit with a damp (not wet) cloth.
• Clean the electrical components with clean, dry cloths that are neither wet nor damp.
• Clean the control unit using a cloth moistened with dilute detergent.
• Never use abrasive or alcohol-based detergents.
• Remember to wipe the equipment if it is wet or damp, after having cleaned it or if it has picked up
water or moisture while you were using it.
WARNING
Never wash your wheelchair using a hose or pressure washer. Only use common household cleaning and
disinfection products.
WARNING
Inflate the tyres to 8 bar
Check tyre pressure regularly to ensure that it is always as close as possible to the recommended value.
Keep your wheelchair fitted with good quality tyres. Contact your dealer if you cannot find the same
tyres as those we recommend (SCHWALBE Marathon Plus or PRIMO Sentinel).
Never replace the pneumatic tyres with solid tyres.
A video is available on the Benoit Systemes YouTube channel under the name
PERFORMANCE CHECKS
The user should regularly check the condition of the equipment to ensure it is used safely. After having
cleaned or repaired the vehicle, you must always check it is working correctly before using it.
• Turn on the controller – Do the indicator lights flash? If they do, this means there is a problem
in the electronic system.
• Test the braking system on a flat surface with clear space of at least 1 m around the wheelchair:
connect the control unit, check that the battery indicator remains lit or flashes slowly; after a
second, push the joystick gently forward until you hear the parking brakes activate (it is possible
that the vehicle will move forward), then immediately release the joystick.
SERVICING AND MAINTENANCE
FOR OPTIMUM USE OF THE PRODUCT,
The Benoit Systemes YouTube channel
1
1
Disengage the left handle and bring it slightly forward.
2
Disengage and bring the right handle against the seat back.
WARNING
If you're not sure you can service your equipment
yourself, contact your approved dealer.
32
2
"Les pneus".