Publicité
Les langues disponibles
Les langues disponibles
INSTALLER CHECKLIST
Your installer must have completed the following:
The dishwasher is square in the cabinetry and leveled.
The dishwasher is fastened securely to the cabinetry.
The dishwasher door opens and closes freely. The dishwasher door must close without hitting any cabinetry
or countertop.
The inlet water supply is turned on and checked for leaks.
The drain hose has been connected and checked for leaks. There must be no kinks or obstructions in the
drain hose.
The drain hose must be installed with a 28" (710mm) high drain loop for drain hook-ups without any air
removed.
If the dishwasher drain is hooked up to a garbage disposal, the drain hopper plug must be removed.
The spray arms are free and rotate freely. The rinse cycle has been run.
The water level will be below the filter screen after the end of the wash program.
It is normal to find some water in the drain filter area.
Set the water softener to the correct water hardness for your area. If the dishwasher drain is connected to a
garbage disposal, make sure that the drain/hopper plug has been removed.
FINAL INSTRUCTIONS
1. Press the On/Off button to turn the dishwasher on.
2. Power indicator light comes on.
3. Use the Program Select button to choose a washing program.
4. Start the program with the Start/Pause/Cancel button.
5. Run the dishwasher through one complete cycle. When the wash cycle is completed, use the On/Off button to
turn the dishwasher off.
SELF-HELP HINTS:
If the screen does not come on:
Check to make sure the breaker to the dishwasher is in the on position.
Check to make sure that the Supply cord is plugged.
If no water is coming into the dishwasher: Check to make sure the hot water shut-off is in the ON position.
If the water does not drain:
Make sure the drain hose is not kinked or comes out of the air gap next to the sink. Remove the drain hose from
the disposal and make sure the plug is removed.
NOTICE:
If your dishwasher is not operating properly after following these steps: Contact your dealer to schedule
an authorized service agent to inspect your new dishwasher for any function-related failure.
The manufacturer warranty does not cover installation, conversion, or customer education service visits.
You will find the model and serial number information on the label located on the right-hand side of the
inner door of your dishwasher, as shown above.
NOTICE:
Please make a copy of your invoice and keep it with this manual and register your dishwasher.
NOTICE:
If the dishwasher does not operate properly, refer to the self-help hints.
16
Publicité
